Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
| reprap_addendum [2007-10-05 15:47] – 192.168.1.48 | reprap_addendum [2007-10-13 12:04] (current) – 192.168.1.46 | ||
|---|---|---|---|
| Line 9: | Line 9: | ||
| * molex connectors (nos. 22-01-3127, 22-23-2021, 22-01-3027, 22-23-2031, 22-01-3037, 22-23-2041, 22-01-3047, 08-50-0114) | * molex connectors (nos. 22-01-3127, 22-23-2021, 22-01-3027, 22-23-2031, 22-01-3037, 22-23-2041, 22-01-3047, 08-50-0114) | ||
| * board mount db9 female | * board mount db9 female | ||
| + | * z-studding-tie | ||
| + | * threaded drive shaft | ||
| === software === | === software === | ||
| Line 17: | Line 19: | ||
| * check m5x20 and m5x30 count | * check m5x20 and m5x30 count | ||
| * 12pin header fr power distribution | * 12pin header fr power distribution | ||
| + | * nichrome length ~370mm | ||
| * cabling lengths (?) | * cabling lengths (?) | ||
| * see annotated howto print-out | * see annotated howto print-out | ||
| + | |||
| + | === calibration / configuration === | ||
| + | * extruder tester getting IO errors, consistently at 96ºC wont report higher temperatures. | ||
| + | * extruder notes -> | ||
| + | * http:// | ||
| + | * the previous version of the thermopast extruder (aka MkII) > http:// | ||
| + | |||
192.168.1.48