Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
Next revisionBoth sides next revision
wormfarm [2012-11-05 16:35] imogenwormfarm [2012-11-05 17:31] imogen
Line 15: Line 15:
 I hunted around Brussels looking for a bath tub, but to no avail, it just wasn't second hand bath tub season at the flea markets. So Plan B: I decided that I'd buy big plastic tubs which stack into each other (you can buy them at hardware store or office supply stores). I decided on a vertical design like this http://www.tumbleweed.com.au/WormFarming.aspx . If you're going to go for layers, I like using a 3 layer system, where you have the top 2 layers to interchange between the upper feeding level and lower 'manifesting' level, and the 3rd bottom layer acting as a drainage system.  I hunted around Brussels looking for a bath tub, but to no avail, it just wasn't second hand bath tub season at the flea markets. So Plan B: I decided that I'd buy big plastic tubs which stack into each other (you can buy them at hardware store or office supply stores). I decided on a vertical design like this http://www.tumbleweed.com.au/WormFarming.aspx . If you're going to go for layers, I like using a 3 layer system, where you have the top 2 layers to interchange between the upper feeding level and lower 'manifesting' level, and the 3rd bottom layer acting as a drainage system. 
  
-Purchase:\\ 3 x blue plastic storage containers\\ 1 x lid\\ 5 x 15cm wooden blocks\\ Threaded tank inlet and washers+Purchase:\\ 3 x blue plastic storage containers\\ 1 x lid\\ 5 x 15cm wooden blocks\\ Threaded tank inlet and washers\\ Total cost: about 50 Euro (could have been cheaper but I had to shop at the inner city hardware store, which was an experience in itself as none of the staff spoke English. Trying to ask for / draw / mime a threaded tank inlet was like playing charades in the dark).
  
 {{:img_1246.jpg?direct&500|}}  {{:img_1246.jpg?direct&500|}} 
  
-Total cost: about 50 Euro (could have been cheaper but I had to shop at the inner city hardware store, which was an experience in itself as none of the staff spoke English. Trying to ask for / draw / mime a threaded tank inlet was like playing charades in the dark). 
  
  
Line 43: Line 42:
  
 {{:img_1253.jpg?direct&500|}} {{:img_1253.jpg?direct&500|}}
 +
 +A slight design flaw is that the bolts I used were very wide. I would have liked to drill the hole at the base of the tub, allowing the liquid to drain out, however the wide bolts created too much height, which would have meant liquid would be sitting in the bottom of the tub. So I went with a side drainage option, which will still mean that some liquid will get stuck in the bottom but it just takes a small tilt of the tub to drain it out. 
  
  
  • wormfarm.txt
  • Last modified: 2012-11-05 20:48
  • by imogen